EGR 103/DAQ 2

This page contains pictures and graphs related to DAQ 2 for EGR 53.

Typographical Errors in the Lab Manual

• DAQ 2-3: After you add two channels, you will receive the following:

Warning: This hardware could not support the requested value of 1000.00 for 
SampleRate. SampleRate has been set to 500.00.

• DAQ 2-6: At the top, the default ranges are now [-10 10] for each entry. That is:

Index:  ChannelName:  HwChannel:  InputRange:  SensorRange:  UnitsRange:  Units:   
1       ''            0           [-10 10]     [-10 10]      [-10 10]     'Volts'  
2       ''            4           [-10 10]     [-10 10]      [-10 10]     'Volts'

Circuit for BasicAOutput

Circuit layout for BasicAOutput.

Circuit for BasicAIO

Circuit layout for BasicAIO (two measurements).

Graph from BasicAIO

Graph showing outputs when

Vout0 = 2.5+2.5*sin(2*pi*k/100);
Vout1 = 2.5+2.5*cos(2*pi*k/100);

That is,

\( \begin{align} V_{out,\,0}=2.5+2.5\sin\left(\frac{2\pi k}{100}\right)\\ V_{out,\,1}=2.5+2.5\cos\left(\frac{2\pi k}{100}\right) \end{align} \)

Circuit for AIO

Circuit layout for AIO (six measurements).

Graph from AIO

Graph showing outputs from six measurement channels.

Questions

Post your questions by editing the discussion page of this article. Edit the page, then scroll to the bottom and add a question by putting in the characters *{{Q}}, followed by your question and finally your signature (with four tildes, i.e. ~~~~). Using the {{Q}} will automatically put the page in the category of pages with questions - other editors hoping to help out can then go to that category page to see where the questions are. See the page for Template:Q for details and examples.