User:DukeEgr93/Arduino 110
Jump to navigation
Jump to search
This page will serve as development space for the ECE 110 conversion to Arduinos.
Lab 1
Connecting the Parallax Digital Trainer to the BOE Shield
This requires two male-to-male 3-header cables.
- The first cable will go from channels GND/13/12 on the BOE Shield to channels GND/P0/P1 on the PDT. The black wire should be on GND; for the BOE Shield, that is the second-to-leftmost pin on the top bus while for the PDT, that is the fourth pin from the top on the left of the socket.
- The second cable will go from channels 2/3/4 on the BOE Shield to P2/P3/P4 on the PDT. The black wire should be on pin 2 of the BOE Shield and in the sixth-from-the-bottom socket on the PDT. The white wire should be on pin 4 of the BOE Shield and in the fourth-from-the-bottom socket on the PDT.
