Controls/Lab/MotorSim

This page contains information related to the Motor Simulation lab for ME 125/ECE 141. It has been updated for Spring, 2011.

Resources

• Relevant Pundit pages
  • gzoom code
• Files for the lab:
  • Specifications for 1624
  • Specifications for 1841
  • MotorLabSample_S11.tex - if getting from a web page, make sure you are saving it using a web browser that started in your UNIX account or transfer it over using SSH or FSecure

Typographical Errors / Clarifications

• On page 7-5, in the top code block, the lsim command will only work if s is already defined; otherwise, you will need to add

  s=tf('s')
  

  to your code before that line.
• On page 7-5, in the middle code block, T should be 0.04 as noted in the paragraph above it.
• Use capital "P" as a subscript for the proportional control and a lower case "p" as a subscript for the steady state error constant of position. For example, in Section 7.8, all the \(K_p\) represent the error constant

Questions

Post your questions by editing the discussion page of this article. Edit the page, then scroll to the bottom and add a question by putting in the characters *{{Q}}, followed by your question and finally your signature (with four tildes, i.e. ~~~~). Using the {{Q}} will automatically put the page in the category of pages with questions - other editors hoping to help out can then go to that category page to see where the questions are. See the page for Template:Q for details and examples.